Clean the surface: Clean the surface where you want to apply the decal using soap and water, then dry it completely with a lint-free cloth. Ensure the surface is free of any oil, dirt, or debris.
Prepare the decal: Remove the decal from its backing paper, being careful not to remove the lamination layer or damage the design.
Position the decal: Carefully position the decal on the surface where you want to apply it.
Apply the decal: Starting from the center of the decal, use a squeegee to smooth out the decal, working outwards towards the edges. This will help to remove any air bubbles or wrinkles.
Check for air bubbles: If you notice any air bubbles, use a needle or pin to puncture the bubble and then use the squeegee to smooth out the decal.
Allow the decal to cure: Leave the decal to cure for at least 24-48 hours before exposing it to water or any other elements.
In summary, to apply a vinyl sticker decal to a metal or plastic surface, you need to clean the surface, prepare the decal, position the decal, apply the decal, check for air bubbles, and allow the decal to cure.
